Quantitative PCR (qPCR) enables precise, accurate DNA quantification. The quality of the starting material is of paramount importance to obtaining reliable, consistent qPCR data. Here, we provide sample preparation considerations to help obtain accurate and consistent results when performing 5’ nuclease assays.
The method of isolation depends on the sample type and experimental conditions. It is important that the sample remains free of nucleases throughout sample preparation and PCR. Following are recommendations for effective sample preparation for qPCR.
Avoid nucleases: RNases and DNases can quickly degrade samples as well as oligonucleotide primers and probes. They are ubiquitous and can be difficult to eliminate. Therefore, precautions must be taken to ensure that samples are protected from these nucleases.
- Thoroughly clean sample preparation areas with 10% bleach solution before you start. Bake glassware and treat non-RNase-free plastics with a 0.1% solution of DEPC for 2 hours followed by rinsing with RNase-free water. Alternatively, IDT provides Nuclease Decontamination Solution, which irreversibly inactivates nucleases and can be applied to most lab surfaces (see below, IDT Product Focus: Reagents for Nucleic Acid Isolation).
- Always wash your hands and wear gloves before handling containers used for RNA sample preparation and storage.
- Use nuclease detection reagents such as RNaseAlert® and DNaseAlert™ Kits to test your samples and reagents (see below, IDT Product Focus: Reagents for Nucleic Acid Isolation).
- If you find contamination in your samples, replace all reagents and stock buffers and thoroughly clean sample preparation areas.
- You can add RNase inhibitors to block the action of some ribonucleases; DNase can be inactivated by heat treatment.
- Regularly decontaminate equipment, such as pipettors and vortex mixers.
Avoid contamination: Treat your RNA sample with DNase to prevent amplification of genomic DNA.
RNA isolation: Be sure to use the isolation method appropriate for your sample type.
- Use the same isolation and quantification methods for all samples being assessed in the same experiment.
- For maximum recovery, use organic extraction methods such as TRIzol® (Invitrogen) or QIAzol® (Qiagen) for small RNAs and miRNAs.
- For high-throughput processing, use solid phase kits.
- Use reagents that are never in contact with potentially contaminating DNA and nucleases by keeping enzyme mixes, nuclease-free water, primers, probes, pipettes, tubes, filter tips, and PCR plates away from areas in which template is present.
RNA storage: For short-term storage (up to a few weeks), store RNA resuspended in water or buffer at –20°C. TE buffer (10 mM Tris, 0.1 mM EDTA) is excellent for this purpose. For longer term storage, precipitate the RNA (1/10 volume 3 M sodium acetate; 2 volumes 100% ethanol) and store it in ethanol at –20°C or –80°C. Before use, remember to pellet and resuspend any RNA that has been stored as a precipitate.
Product focus: Reagents for nucleic acid isolation
RNase Alert™ and DNase Alert™ Kits
RNase Alert™ and DNase Alert™ Kits enable rapid, sensitive detection of RNases and DNases. The kits contain fluorescence-quenched probes that emit a fluorescent signal only after nuclease degradation. The signal can be read visually or measured and quantified using fluorometry. Use the assays to test lab reagents, equipment, and supplies for nuclease contamination, or quantitatively to study enzyme kinetics.
Learn more about RNase and DNase Alert Kits
Nuclease Decontamination Solution
Nuclease Decontamination Solution irreversibly inactivates nucleases. It simplifies sterilizing difficult-to-treat plastic surfaces, and eliminates the need to bake glassware. Just spray, rinse, and let dry.
Learn more about Nuclease Decontamination Solution
Find out more about qPCR assay design:
Review other DECODED Online newsletter articles on PCR and qPCR applications.
You can also browse our DECODED Online newsletter for additional application reviews, lab tips, and citation summaries to facilitate your research.
Author: Nicola Brookman-Amissah, PhD, is a senior scientific writer at IDT.
© 2012, 2016 Integrated DNA Technologies. All rights reserved. Trademarks contained herein are the property of Integrated DNA Technologies, Inc. or their respective owners. For specific trademark and licensing information, see www.idtdna.com/trademarks.